Viking 42inch 500 TruSear VGBQ Outdoor Kitchen Planning Guide - Page 12
When to Use Inside and Outside Filler Strips Together see sample drawing below
View all Viking 42inch 500 TruSear VGBQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
PLANNING YOUR VIKING OUTDOOR KITCHEN When to Use Inside and Outside Filler Strips Together (see sample drawing below) In situations where the back of your cabinet layout is exposed, such as in an island setting, inside and outside filler strips will need to be used. Use a 90° (VCF90) or 135° (VCF135) inside filler whenever you have a 90 or 135 degree turn. Depending on which turn you are accounting for, a 90° (VOCF90) or 135° (VOCF135) outer corner back panel assembly must be used to complete the layout. These assemblies consist of a 4"W. stainless steel "post", two mounting brackets, and two stainless steel back panels. The post is placed in the middle corner of the void area (see diagram below) and the back panels are attached to it. The post gives support to the void area underneath the countertop that falls in between the cabinets. Next, the supplied brackets are attached to the inside of the two adjacent cabinets in the run. The stainless steel back panels are then attached to the brackets and fit flush with the back panels attached to the back of the cabinets to the right and left of the VSP30 VOCF90 Back Panel VBP18 VBP16 VBPFLR4 VBP30 VOCF90 Back Panel VBO1811 VBBO1601 VQBO3021 VOCF90 VFLR4 VCF90 VBO1830 VSP30 VSP30 VBP18 13