Viking DFB450 Specs - Page 3

KITCHEN CLEANUP Built-In 24"W. Dishwasher 450E UTILITY REQUIREMENTS GAS Not applicable Installation Requirements ACCESS REQUIREMENTS ELECTRICAL • 3'9" (1.1 m), electrical cord with 90 degree 3-prong plug • 120V/60 Hz • Maximum amp usage-15.0 amps • Water-heating element rating- 1,200 watts VDB450E Professional Built-In Dishwasher DFB450E Custom Front Built-In Dishwasher See Custom Panels section for more information and additional specifications. PLUMBING • 120°F (49°C) hot water recommended; dishwasher will, however, perform properly with cold water* • Inlet water pressure operating range- 10 - 125 psi (0.69 - 8.62 bar) • Five foot (1.5 m) braided stainless steel water line with 3/8" (0.95 cm) compression fitting supplied with dishwasher • Seven-foot (2.13 m) 1/2" (1.3 cm) ID "crimp-proof" flexible drain hose with clamp attached to dishwasher; connections provided for 5/8" (1.5 cm), 3/4" (1.9 cm), or 1" (2.5 cm) cut as required • High loop of drain hose required; min. height from floor- 20" (50.8 cm) • Check local codes for drain air gap requirement *Cycle times will be extended Cutout width Cutout height Cutout depth (612.04"cm) (612.04"cm) 33((885469""..t40momccamminx)).. A 2" cut-out is required for water supply and discharge lines. All models 24" (61.0 cm) 34" (86.4 cm) min. to 35" (89.0 cm) max. 24" (61.0 cm) PLANNING AND DESIGN GUIDE VIKINGRANGE.COM • 1-888-VIKING1 REVISED 4/29/11 © 2 0 1 1 V R C - INFORMATION SUBJECT TO CHANGE