Viking DFB450 Installation Instructions

Viking DFB450 Manual

Get Viking DFB450 PDF manuals and user guides View all Viking DFB450 manuals
Add to My Manuals
Save this manual to your list of manuals

Viking DFB450 manual content summary:

  • Viking DFB450 | Installation Instructions - Page 1
    Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com F20828 EN Professional & Designer 200/325E/450E Series Built-In Dishwashers (
  • Viking DFB450 | Installation Instructions - Page 2
    Service & Registration 22 IMPORTANT-Please Read and Follow! • Before beginning-please read these instructions completely and carefully. • Do not remove permanently affixed labels, warnings, or rating plates from the dishwasher to the product. Wiring the dishwasher with more voltage than it is
  • Viking DFB450 | Installation Instructions - Page 3
    follow these instructions, can result in death, fire or electrical shock. WARNING Tip Over Hazard Do not use dishwasher until completely installed significant sources of water or moisture. • Viking Range Corporation will NOT warranty any problems resulting from GFI outlets which are not installed
  • Viking DFB450 | Installation Instructions - Page 4
    Panel Flush 26-3/8" (67.0 cm) 23-3/4" (60.3 cm) Designer Series 26-3/8" (67.0 cm) 23-1/8" (59.0 cm) 2-1/4" Model: 120°F (49°C) required 325E/450E Models: 120°F (49°C) recommended; Dishwasher will perform properly with cold water Note: Cycle times will vary Inlet water pressure operating range
  • Viking DFB450 | Installation Instructions - Page 5
    Custom Door Panel (Specifications for FDB200/DFB450E Models) 10" (25.4 cm) 11-17/32" (29.3 cm) 5/8" in most cabinets. Ensure that the design, construction, and installation of the panel and MUST BE stainless steel to avoid corrosion. If dishwasher has a metal door skin installed, remove the four
  • Viking DFB450 | Installation Instructions - Page 6
    NOTE: Be sure to run the drain line through the hole to the sink compartment before moving the dishwasher into place. 10 General Information Electrical Connections Grounding Instructions This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of
  • Viking DFB450 | Installation Instructions - Page 7
    . NOTE: Be careful not to pinch hoses or power cord beneath dishwasher. c Remove bottom pan and front plate. Rapid removal of the bottom pan will cause damage to the moisture sensor. To remove the bottom pan for installation and servicing, slowly pull the bottom pan from the unit and disconnect the
  • Viking DFB450 | Installation Instructions - Page 8
    , remove the 6 screws (3 per side) holding side trim on. Shift the side trim forward. Use rear hole on side trim and the same hole on dishwasher to reattach trim. If needed, attach wiper gasket by pulling protective film off adhesive back on wiper gasket and apply behind hemmed edge of side
  • Viking DFB450 | Installation Instructions - Page 9
    the brackets will already be in the base. NOTE: Be careful not to pinch hoses or power cord beneath dishwasher. 2 To adjust the depth of the kick plate, loosen screws on the bracket and position in the required and right adjust side to side and center adjusts front to back. (Select models only) 17
  • Viking DFB450 | Installation Instructions - Page 10
    . To level center rear leg, see Step 5a. Front Panel Removed 18 Installation Procedure (cont'd.) 7 7b Attach screws through trim pieces into cabinets. (select models). 8 Minimum 20" (50.8 cm) from floor Install High Loop Clip, which is provided, a minimum of 20" (50.8 cm) from the floor. 10A
  • Viking DFB450 | Installation Instructions - Page 11
    (select models only) and install kick plate. Performance Checklist Testing for Leaks A qualified installer should carry out the following checks: h Remove packaging and parts. h Turn on the water supply and check for leaks. h Turn the power on at breaker/fuse box and test the dishwasher operation
  • Viking DFB450 | Installation Instructions - Page 12
    part of the appliance unless specifically recommended in the manual. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to: VIKING RANGE CORPORATION PREFERRED SERVICE
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information,
call 1-888-VIKING1 (845-4641)
or visit the Viking Web site at
vikingrange.com
F20828 EN
(040511)
Professional & Designer 200/325E/450E Series
Built-In Dishwashers
Viking Installation Guide