Viking DFB450 Installation Instructions - Page 2

Table of Contents Warnings & Important Information 3 Dimensions & Cutout Dimensions 6 Specifications 7 Custom Door Panel Specifications 8 Custom Door Panel Installation Option 9 General Information 10 Site Preparation 10 Water Supply 10 Drain 10 Electrical Connections 11 Hardwire Conduit Option 12 Trim Installation Options 13 Counter Balance Spring Adjustment 16 Installation Procedure 17 Performance Checklist 21 Testing for Leaks 21 Final Preparation 21 Service & Registration 22 IMPORTANT-Please Read and Follow! • Before beginning-please read these instructions completely and carefully. • Do not remove permanently affixed labels, warnings, or rating plates from the dishwasher. This may void warranty or create an unsafe product. • Please observe all national and local codes. WARNING Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, hertz, and amps is attached to the product. Wiring the dishwasher with more voltage than it is rated for may cause severe damage. To reduce the risk of fire, electric shock, or injury to persons, installation work and electrical wiring must be done by qualified technician in accordance with all applicable codes and standards, including fire-rated conditions. WARNING Electrical power must be turned off at circuit breaker or fuse box before making electrical connections. Disconnect the electrical power supply and place a tag at the disconnect switch indicating that you are working on the circuit. • Please ensure that this product is properly grounded. • The installer should leave these instructions with the consumer who should retain for local inspector's use and for future reference. • The dishwasher has a factory installed backflow preventer. Do not add an additional check valve. • Failure to provide a 20" above floor level (50.8 cm) high loop may result in improper operation of the dishwasher. • Remove pallet screws from base. Damage could occur to dishwasher if screws are not removed. WARNING Plumbing connections must comply with applicable sanitary, safety and plumbing codes. WARNING The dishwasher door may not stay open by itself until the door panel is installed. Be aware of this when fastening the dishwasher to the cabinet. Site Preparation It is recommended that a thorough site inspection be conducted PRIOR to unpacking and moving this appliance. 2 3