Viking DMOD241SS Installation Instructions - Page 2
Clearances And Dimensions, Drawermicro, Oven Measurements - 24
View all Viking DMOD241SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Clearances and Dimensions • Dimensions that are shown in FIGURE 1 must be used. Given dimensions provide minimum clearance. Locate electrical outlet in the shaded area in the upper lefthand corner of the cutout. See FIGURE 4. • Contact surface must be solid and level. Pay special attention to the floor on which the appliance will sit. The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (about 100 pounds). • Check location where the DrawerMicro Oven will be installed for proper electrical supply. • Your appliance can be built into a cabinet or wall by itself or under a gas or electric wall oven. • Be sure that the clearance of the floor between the wall oven and the DrawerMicro Oven is a minimum of 2". • The microwave interior will easily accommodate a 9" x 13" oblong dish or a bag of microwave popcorn. DrawerMicro Oven Measurements Electrical outlet location 5" (6") Anti-Tip block 3 56O" 36" countertop height 4" 22 56 " opening Allow ¾" overlap. 23 ½" Allow ¾" min depth overlap. Allow RQE" overlap 14 5RQE" opening 14 5RQE" to bottom of Anti-Tip block Allow (RQE" overlap Floor must support 100 lbs. 19" to top of floor 24" cabinet min. FIGURE 1 FIGUREs 1 and 2 contain many DrawerMicro Oven measurements for reference when planning the drawer's location. 4 556QE" 1 36:O" 21 56:O" 15 6 " FIGURE 2 23 (6 " 14 56:O" 15" auto drawer opening 23 6 " 1 6M" door thickness The DrawerMicro Oven can be installed below any electric or gas wall Oven. * Can also be installed using an electrical outlet in an adjacent cabinet within the area where the provided electrical cord can reach. Power cord access hole in cabinet should be a minimum 1½" diameter hole and deburred of all sharp edges. IMPORTANT Always allow sufficient power cord length to the electrical outlet to prevent tension. DO NOT USE AN EXTENSION CORD. Always check electrical codes for requirements. E2