Viking DSCD1304BSS Installation Instructions
Viking DSCD1304BSS Manual
 |
View all Viking DSCD1304BSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Viking DSCD1304BSS manual content summary:
- Viking DSCD1304BSS | Installation Instructions - Page 1
Viking Installation Guide ® Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com F20649A EN Designer Freestanding 30" Dual Fuel Self-Clean Sealed Burner Range - Viking DSCD1304BSS | Installation Instructions - Page 2
24 Service & Registration 25 2 IMPORTANT-Read and Follow! • Before beginning, please read these instructions completely and of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is - Viking DSCD1304BSS | Installation Instructions - Page 3
moisture. • Viking Range Corporation will NOT warranty any problems resulting from IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, instructions. -If you cannot reach your gas supplier, call the fire department. • Installation and service must be performed by a qualified installer, service - Viking DSCD1304BSS | Installation Instructions - Page 4
accepts standard residential 1/2" (1.3 cm) ID gas service line Gas Manifold Pressure Natural 5.0" W.C.P./ Liquid Propane construction: Below cooking surface (36" [91.4 cm] and below) • Sides - 0" • Top grate support - 36" (91.4 cm) Above cooking surface (above 36" [91.4 cm]) • Sides - 6" - Viking DSCD1304BSS | Installation Instructions - Page 5
result in the bottom of the hood being 66" (167.6 cm) to 72" (182.9 cm) above the floor. Refer to the range hood installation instructions for additional information. These dimensions provide for safe and efficient operation of the hood. Note: Minimum clearance for back wall is 0" with backguard or - Viking DSCD1304BSS | Installation Instructions - Page 6
240-208 VAC/60 Hz. See "Electrical Connection" section for grounding instructions. Must be fused seperately from any other circuit. WARNING Electrical shock qualified licensed plumber or gas service company. Please provide the service person with this manual before work begins. Pressure Regulator: - Viking DSCD1304BSS | Installation Instructions - Page 7
. If you notice the cooling fan is not operating or you observe unusual or excessive noise coming from the cooling fan, contact a Viking Authorized Service Center before continuing operation. Failure to do so can result in damage to the oven or surrounding cabinets. Moving, Handling, and Unpacking - Viking DSCD1304BSS | Installation Instructions - Page 8
and internal mounting hardware. 14 Electrical Connection (3-wire) Note: If you have a 4-wire connection, see following section for 4-wire connection instructions. WARNING Electrical shock hazard. To avoid risk or electrical shock, personal injury or death; grounding product to the frame of the - Viking DSCD1304BSS | Installation Instructions - Page 9
Electrical Connection (3-wire) (cont.) 4 5 1 Attach line #1 (red) and line #2 (black) leads to outside terminal. Attach neutral wire (white) to center terminal on the terminal block. 6 Push supply cord toward terminal block to relieve strain, reattach supply cord strain relief bracket over - Viking DSCD1304BSS | Installation Instructions - Page 10
Electrical Connection (4-wire) (cont.) 4 5 Feed supply cord up through hole in bottom of range back. 6 Attach ground lead (green) with ground screw that was removed. 7 1 Attach line #1 (red) and line #2 (black) leads to outside terminal. Attach neutral wire (white) to center terminal on - Viking DSCD1304BSS | Installation Instructions - Page 11
personal injury or death; leak testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • DO performed by your dealer, a qualified licensed plumber, or gas service company. 21 - Viking DSCD1304BSS | Installation Instructions - Page 12
Final Installation 1 2 Slide range into place. Be sure anti-tip bracket slides into the anti-tip opening. 3 Burner heads and burner caps are packed in the cardboard top pack with the grates. Align burner head on burner base. Place burner cap on burner head. Place grate onto the burner pan. (03 - Viking DSCD1304BSS | Installation Instructions - Page 13
front edge of the bottom base. Record the following information indicated below. You will need it if service is ever required. Model number Serial number Date of purchase Date installed Dealer's name Address These installation instructions should remain with the unit for future reference. 25 - Viking DSCD1304BSS | Installation Instructions - Page 14
26 27
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
 |
 |
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information,
call 1-888-VIKING1 (845-4641)
or visit the Viking Web site at
vikingrange.com
F20649A EN
(081610)
®
Viking Installation Guide
Designer Freestanding 30” Dual Fuel
Self-Clean Sealed Burner Range