Viking DTWN3648SS Installation Instructions - Page 23
To install ventillation kit, refer to ventillation kit, installation instructions.
View all Viking DTWN3648SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
12 1 13 1 3 2 3 2 Slide spacer front over front lip. Push spacer rear up, Slide filter front over front lip. Push filter rear up, then then slide back over rear lip. slide back over rear lip. Installation (DCWH/DCWN/DCWL Classic Chimney & DTWN Tall Traditional Wall Hoods) 1 1-1/2"x 3/4" (3.8 cm) x (1.9 cm) wood strip 1(4-.163c/1m6)" 5/16" nut driver 2 Slot for wood strip 5/16" nut driver Measure down 1-13/16 (4.6 cm) from desired height of hood and secure 1-1/2" x 3/4" wood strip (not included) to wall using screws provided. 3 5/16" nut driver Use additional mounting screws to secure hood to wood strip. 5/16" nut driver CAUTION: Secure vent hood to wall using screws provided. Make sure mounting screws are secured into frame. Use additional mounting screws and wall anchors, if necessary. CAUTION: If not using a duct cover, using screws provided make sure top mounting screws are secured into soffit or cabinet frame. Use additional mounting screws, if necessary. 44 To install ventillation kit refer to ventillation kit installation instructions. 5 1 4 1 2 3 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 6 1 2 3 Slide spacer front over front lip. Push spacer rear up, then slide back over rear lip. 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. Duct Cover Option (DCWH/DCWN/DCWL Classic Chimney Wall Hoods) 1 2 Measure distance from ceiling to canopy. 45 Tape to avoid scratching.