Viking FPIM515 Right Hinge Professional Ice Machine Door Panel - PIDP15TR - In - Page 1
Viking FPIM515 Manual
View all Viking FPIM515 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
ICE MACHINE ACCESSORY DOOR PANEL INSTALLATION ACCESSORY DOOR PANEL The ice machine is supplied without a finished door panel. Accessory door panels are offered or a custom panel may be used. Accessory Door Panel Attachment Note: If door swing is to be changed, it must be done before panel is attached (See Installation Instructions). Hole plug Cover Gasket To attach a door panel: The panel will be held on by 6 screws and 2 machine screws (supplied). 1. Remove the gasket and retain for later use. 2. If the door panel is stainless steel, remove any plastic covering the stainless steel panel. 3. Place the panel onto the outside of the door, and secure it to the door using two machine screws, located at the left center and right center (behind door gasket). 4. Fasten the panel to the door using the 6 screws (supplied in kit). In the hinge area, use the outermost screw holes. 5. Place the covers over the hinge areas, and secure each cover to the door using a screw (supplied). 6. Insert hole plug over screw installed in step 5 (supplied). 7. Return the gasket to its original position. ACCESSORY DOOR PANEL ATTACHMENT Use Upper Hole at the Top Accessory Door Panel Gasket F20759A EN Machine Screw Hole Plug Cover Use Lower Hole at the Bottom (120610)