Viking FPIM515 Designer Stainless Steel Handle Kit - 29 inch - Installation In - Page 2

IMPORTANT-Please Read and Follow! • Before beginning, please read these instructions completely and carefully. • Use caution during assembly to minimize scratches. • Do not remove permanently affixed labels, warnings or plates from the product. This may void the warranty. • Please refer to the DFUR, DFUW, DFRI, DFIM, DFWD101 Installation Instructions for more information on installing the door panel. • The installer should leave instructions with the customer who should retain for local inspector's use and future reference. Installation with Wooden Full Overlay Custom Door Front Parts Included Part Designer Handles #10 x 3/4" Hex Head Screws Installation Instructions Quantity (1) (4) Required Tools Electric Drill 3/16" (0.5 cm) Drill Bit 7/16" (1.1 cm) Spade or Forstner Bit (Counterbore) Tape Measure Hex Head Screw Driver Masking Tape and Pencil To Install: 1. Locate the wooden custom panel. 2. Using the illustrations on the next page, layout the handle location on the panels. It is recommended that masking tape be placed where the four holes will be drilled to help mark the hole placement and to prevent any damage to the door when drilling the holes. 3. The Designer handle will be mounted using (4) of the #10 x 3/4" Hex head screws provided. Using the 3/16"(0.5 cm) drill bit, drill completely through the door in the hole locations. Using the 7/16" (1.1 cm) bit, counter-bore four holes 1/2" (1.2 cm) deep max. on the BACKSIDE of the custom door panel. 4. Attach the Designer handle to the panel using (4) #10 x 3/4" screws provided. 2 Handle Installation CL DFUW - WINE CELLAR DFIM - ICE MACHINE DFUR - BEVERAGE CENTER DFRI - COMBINATION BEVERAGE CENTER/ICE MAKER Section A-A 26-7/16" (67.2 cm) CL A 13/16" (2.1 cm) A 13/16" (2.1 cm) 3/4" (1.9 cm) Full Overlay Panel 7/16" (1.1 cm) Counter Bore x 1/2" Depth (max) 3/16" (0.5 cm) Thru Hole 3