Viking RDDFF236SS Installation Instructions - Page 8

Doors & Drawer Removal Remove and Replace Handles 1. Using a 3/32"or 1/8" hex wrench, loosen the two set screws located on the side of each handle. 2. Pull the handle straight out from the door. Make sure you keep the screws for reattaching the handles. 3. To replace the handles, reverse the directions. Remove Doors and Hinges IMPORTANT: Remove food and any adjustable door or utility bins from doors. TOOLS NEEDED: 5/16", 3/8", 1/4" hex-head socket wrench, #2 Phillips screwdriver, and a flatblade screwdriver. 1. Unplug refrigerator or disconnect power. 2. Keep the refrigerator doors closed until you are ready to lift them free from the cabinet. Note: Provide additional support for the refrigerator door while the hinges are being removed. DO NOT depend on the door gasket magnets to hold the door in place while you are working. 3. Starting with the right-hand side door, remove the parts for the top hinge as shown in Top Hinge graphic. Lift the refrigerator door from the bottom hinge pin. Note: Remove the hinge pin cover from the bottom hinge pin and keep for later use. See Bottom Hinge graphic. 4. Before removing the left-hand side door, disconnect the wiring plug located on the top of the top hinge by wedging a flat-blade screwdriver or fingernail between the two sections. See Wiring Plug graphic. Remove Doors and Hinges (cont.) 6. Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the left-hand side door from the bottom hinge pin. Note: Remove the hinge pin cover from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic. Top Hinges A B C D A. Hinge Cover Screw B. Top Hinge Cover C. 5/16" Hex-Head Hinge Screws D. Top Hinge Bottom Hinges A B C A. Hinge Pin Cover B. Bottom Hinge C. Hinge Screws Wiring Plug 14 Door & Drawer Removal (cont.) Replace Doors and Hinges 1. Assemble the parts for the top hinge as shown in Top Hinge graphic. DO NOT tighten the screws completely. 2. Replace the parts for the bottom hinge as shown in Bottom Hinge graphic. Tighten screws. Replace the refrigerator door. Note: Provide additional support for the refrigerator door while the hinges are being moved. DO NOT depend on the door gasket magnets to hold the door in place while you are working. 3. Align the door so that the bottom of the refrigerator door aligns evenly with the top of the freezer drawer. Tighten all screws. 4. Reconnect the wiring plug on top of the lefthand side refrigerator door. 5. Replace the top hinge covers. Remove and Replace Freezer Drawer IMPORTANT: Two people may be required to remove and replace the freezer drawer. Remove Drawer Front 1. Open the freezer drawer to full extension. 2. Loosen the four screws attaching the drawer glides to the drawer front. See Drawer Front Removal graphic. Note: Loosen screws three to four turns. Keep the screws in the drawer front. 3. Lift drawer front upward and off the screws. See Drawer Front Removal graphic. Replace Drawer Front 1. Slide the drawer glides out of the freezer compartment. Insert the screws in the top of the drawer front into the slots in the drawer brackets. See Drawer Front Replacement graphic. 2. Pull the drawer brackets toward you to position the two screws in the bottom of the drawer front into the brackets. See Drawer Front Replacement graphic. 3. Completely tighten the four screws. Drawer Front Removal A A. Loosen 4 Door Bracket Screws Drawer Front Replacement 15