Viking RDEWD103SS Installation Instructions - Page 4
Cutout Dimensions, Electrical Requirements, Electrical Connection
View all Viking RDEWD103SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Cutout Dimensions - RDEWD C A Indoor RDEWD103 Cutout width (A) 28-1/4" (71.8 cm) Cutout depth (B) 23-1/2" (59.7 cm) Cutout height (C) 9-1/4" (23.5 cm) Flush Mount Option: Note: To install the warming drawer in a flush mount application, a flush mount accessory kit is required and sold separately. B RDEWD103 Cutout width (A) 29-5/8" (75.3 cm) Cutout depth (B) 25-1/8" (63.8 cm) Cutout height (C) 10-1/8" (25.7 cm) Electrical Requirements Electrical Requirements Check your national and local codes regarding this unit. Hard wire direct with seperate 120V/15 amp minimum 2-wire wtih ground circuit. Maximum amp usage. Max. amp usage RDEWD103 450 watts 3.8 amps Electrical Connection Note: Use copper conductors ONLY! Grounding Instructions This appliance must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance. With the appliance positioned in front of the cabinet opening, connect wire leads extending from the power supply to the terminal block of the unit. Make sure the colored wires of the terminal block are connected to the corresponding colored wires extending from the power supply. WARNING Electrical shock hazard. To avoid the risk of electrical shock, personal injury or death; verify electrical power is turned off at the breaker box until the range is installed and ready to operate, installation by an authorized installer only. 6 7