Viking RDSCE230 Installation Instructions - Page 10
Leveling/Adjustments/Alignment, cont.
View all Viking RDSCE230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Electrical Connection (4-wire) (cont.) Bare Wire Connection Eyelet Connection 4 1 1 To make a bare wire connection, use holes on the left side of the terminal block. To connect eyelet style wires, use holes on right side of terminal. 5 Feed supply cord up through hole in bottom of range back. 6 1 2 Attach ground wire (green) with ground screw that was removed. 7 1 1 2 Attach line #1 (black) and line #2 (red) leads to outside terminal. Attach neutral wire (white) to center terminal on terminal block. 8 1 3 Push supply cord toward terminal block to relieve strain, reattach supply cord strain relief bracket over supply cord. 18 2 Reattach access door. Leveling/Adjustments/Alignment 1 2 Measure the four corners in cutout area to verify if flooring is level. 3 For uneven or sloped floors, level unit with metal shims only, as the adjustment required may exceed the thread available in the leg. 4 Move unit into opening. 5 (03.9/58"cm) Check that unit is level side to side and front to back. Side trim of the high corner must be 3/8" (0.95 cm) above countertop. 6 If leveling is required, move unit out of opening. 19 1 1 2 Lift unit and prop on wood blocks.