Viking TVDR361 LP Conversion Kit Instructions
Viking TVDR361 Manual
 |
View all Viking TVDR361 manuals
Add to My Manuals
Save this manual to your list of manuals |
Viking TVDR361 manual content summary:
- Viking TVDR361 | LP Conversion Kit Instructions - Page 1
call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. •If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency, or the gas supplier. CAUTION Be sure the electric power is - Viking TVDR361 | LP Conversion Kit Instructions - Page 2
Regulator Conversion •Remove hex nut from top of regulator. •Unsnap plastic plunger from hex nut. •Reverse plunger and reinstall onto hex nut by pressing firmly. NOTE: Plunger is marked "NAT" or "LP". Converted fuel type will be shown on the lower portion of plunger. •Reinstall hex nut onto - Viking TVDR361 | LP Conversion Kit Instructions - Page 3
Surface Burner Conversion Remove grates, surface burner caps and frenchtop (if applicable) Surface Burner Conversion -Locate appropriate orifice -Remove screw (Item #1) flat-head screwdriver. -Lay the burner flange to side - do not disconnect the igniter wire. (Item #2). -Use a nut driver to remove ori - Viking TVDR361 | LP Conversion Kit Instructions - Page 4
Rating Label Location When the LP/Propane conversion is complete, complete the enclosed conversion label and place it next to the rating label. The rating label is located under the control panel. 7KLVDSSOLDQFHZDVFRQYHUWHGRQ 1DWRU E\ /3JDV GD\PRQWK\HDUWR QDPHDQGDGGUHVVRIRUJDQL] - Viking TVDR361 | LP Conversion Kit Instructions - Page 5
Guide d'installation LPKTVDR LP Kit de Conversion pour Cuisinières Tuscany Contenu du kit de conversion de l'orifice PL Description Brûleurs de surface arrière (B) Brûleurs de surface arrière (C) Brûleurs de surface avant (D) Plaque Française (F) Étiquette de conversion Instructions de conversion - Viking TVDR361 | LP Conversion Kit Instructions - Page 6
Conversion du régulateur •Déposer l'écrou hexagonal du dessus du régulateur. •Ôter le piston plastique de l'écrou hexagonal. • Inverser le piston et le réinstaller sur l'écrou hexagonal en appuyant fermement. REMARQUE : Le piston porte les marques « NAT » ou « PL ». Le type de combustible converti - Viking TVDR361 | LP Conversion Kit Instructions - Page 7
Surface Burner Conversion Déposer toutes les grilles, têtes de brûleur de surface et la plaque française Conversion du brûleur de surface -Localiser l'orifice approprié -Déposer tournevis à tête plate vis (Article n°1). -Poser la bride brûleur de côté - ne débranchez pas le câble de l'allumeur. ( - Viking TVDR361 | LP Conversion Kit Instructions - Page 8
Emplacement de l'étiquette de caractéristiques nominales Lorsque la conversion du PL/Propane est terminée, remplir l'étiquette de conversion ci-jointe et la placer à côté de l'étiquette de caractéristiques nominales. L'étiquette de caractéristiques nominales est située sous le panneau de commande.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Installation Guide
LPKTVDR LP Conversion Kit
for Tuscany Ranges
Description
Part Number/Size
Quantity
Rear Surface Burner (B)
#78
1
Rear Surface Burners (C)
#105
2
Front
Surface Burner (D)
#120
3
Frenchtop Burner (F)
#90
1
Conversion label
PF030377
1
LPKTVDR Conversion Instructions
056242-000
1
LP Orifice Conversion Kit Contents
NOTE:
Depending on the model being converted, some of the orifices may not be used.
IMPORTANT - Please Read and Follow!
WARNING
FIRE/EXPLOSION
HAZARD
If the information in this
guide is not followed exactly, a
fi
re or
explosion may result causing property
damage, personal injury or death.
WHAT TO DO IF YOU SMELL GAS:
•
DO NOT
try to light any appliance.
•
DO NOT
touch any electrical switch.
•
DO NOT
use any phone in your building.
•Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
•If you cannot reach your gas supplier, call
the
fi
re department.
Installation and service must be performed
by a quali
fi
ed installer, service agency, or
the gas supplier.
CAUTION
Before placing the appliance
into operation, always check for
gas leaks with a soapy water
solution or other acceptable method.
DO NOT
use an open
fl
ame to check for
leaks.
CAUTION
Be sure the electric power
is turned off at the breaker
box while the unit is being
converted.