Viking VDSC536T Installation Instructions

Viking VDSC536T Manual

Get Viking VDSC536T PDF manuals and user guides View all Viking VDSC536T manuals
Add to My Manuals
Save this manual to your list of manuals

Viking VDSC536T manual content summary:

  • Viking VDSC536T | Installation Instructions - Page 1
    Viking Installation Guide ® Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com F20533E EN Professional Freestanding Dual Fuel Ranges (080610)
  • Viking VDSC536T | Installation Instructions - Page 2
    , always operate this unit according to the instructions contained in this book and provide good ventilation. Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages
  • Viking VDSC536T | Installation Instructions - Page 3
    device packed with range. • See installation instructions. DANGER Gas leak hazard. To avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with soapy
  • Viking VDSC536T | Installation Instructions - Page 4
    "ainx.. Note: Unit shown with standard island trim. 6 Dimensions Dual Fuel 30", 36", 48" and 60" W. Ranges 8-1/8" (20.6 cm) 28-1/16" (71.2 cm) 26-7/16" ( cm) standoff is included on each 48" and 60"W. VDSC model range and is required for installation against a combustible wall. These standoffs can
  • Viking VDSC536T | Installation Instructions - Page 5
    of high shelf - add 23-1/2" (59.7 cm) Gas Requirements Shipped Natural or LP/Propane, field convert with conversion kit (purchased separately); accepts standard residential 1/2" (1.3 cm) ID gas service line Gas Manifold Pressure Natural 5.0" W.C.P./ Liquid Propane L/P 10.0" W.C.P. Electrical
  • Viking VDSC536T | Installation Instructions - Page 6
    cabinet countertop. This can be accomplished by raising the unit using the adjustment spindles on the legs. • The range CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical surfaces above 36" (91.4 cm) high. There must be a minimum of 6" (15.2 cm
  • Viking VDSC536T | Installation Instructions - Page 7
    or liquid propane (LP) gas. Before beginning installation verify that the model is compatible with the intended gas supply. 12 Electrical & Gas Requirements Manual shut-off valve: The installer-supplied valve must be installed in the gas service line before the appliance in the gas stream and in
  • Viking VDSC536T | Installation Instructions - Page 8
    Viking Authorized Service Center before continuing operation. Failure to do so can result in damage to the oven tip metal bracket supplied with the range. This is the anti-tip device and tip Device Installation" section. Some stainless steel parts may have a plastic protective wrap which must
  • Viking VDSC536T | Installation Instructions - Page 9
    following section for 4-wire connection instructions. WARNING Electrical shock hazard. To shock, personal injury or death; verify your appliance has been properly grounded in accordance with local cord or conduit must be secured to the range with the strain relief bracket. The electrical connection
  • Viking VDSC536T | Installation Instructions - Page 10
    VDSC560 ranges contain two access doors and terminal blocks. Either location can be used for the power supply dependent on the receptacle location or length of power supply wiring. 2 WARNING Electrical shock hazard. To avoid risk of electrical shock, personal injury or death; verify your appliance
  • Viking VDSC536T | Installation Instructions - Page 11
    Electrical Connection (4-wire) (cont.) 4 5 Feed supply cord up through hole in bottom of range back. 6 Attach ground lead (green) with ground screw that was removed. 7 1 Attach line #1 (red) and line #2 (black) leads to outside terminal. Attach neutral wire (white)
  • Viking VDSC536T | Installation Instructions - Page 12
    each range width. Anti-tip Device Installation (cont.) 3 4 Mark and drill holes where bracket will be located. Connecting Gas & Electric DANGER Gas leak hazard. To avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer's instructions
  • Viking VDSC536T | Installation Instructions - Page 13
    caps are packed in styrofoam top pack with the grates. Place burner on top of range. Place burner grate on top of burner cap and grate support. Note: Arrow on burner cap must be pointing towards back of range. (03.9/58"cm) Check that unit is level side to side and front to
  • Viking VDSC536T | Installation Instructions - Page 14
    inside oven. This could cause them to discolor due to the high temperature required for self-cleaning. 26 Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information,
call 1-888-VIKING1 (845-4641)
or visit the Viking Web site at
vikingrange.com
F20533E EN
(080610)
®
Viking Installation Guide
Professional Freestanding Dual Fuel Ranges