Viking VGBQ3002RE2NSS Use and Care Manual - Page 16
Cleaning and Maintenance, Troubleshooting
View all Viking VGBQ3002RE2NSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Product Care Cleaning and Maintenance Replacing Interior Halogen Canopy Lights CAUTION DISCONNECT THE ELECTRIC POWER BEFORE REPLACING BULB. Do not touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth. glass light cover 1. Unsnap glass light cover using a screwdriver in the access groove. access groove 2. Firmly grasp light bulb and pull out. 3. Replace with halogen bulb using volt and wattage light requirements listed on glass bulb cover. 4. Replace the light cover by snapping glass cover onto metal box. 5. Reconnect power. Spider Inspection You should inspect the burners/venturi tubes at least once a year, or immediately if any of the following conditions occur. • The smell of gas along with the burner flames appearing yellow. • The grill does not reach the proper temperatures. • The grill heats unevenly. • The burners make a popping noise. WARNING SPIDER AND INSECT INFESTATION Spiders and insects can nest in the burners/venturi tubes of this or any other grill, and cause the gas to flow from the front of the burner. This is a very dangerous condition that can cause a fire to occur behind the valve panel, thereby damaging the grill and making it unsafe to operate. 30 Troubleshooting PROBLEM POSSIBLE CAUSE AND/OR REMEDY T-Series grill won't light when the ignitor is pressed Make sure the control knob is off (no gas is on). Remove the grill rack and the flavor generator plates. Watch the ignitor tip. You should see a spark jump from the tip of the ignitor when the button is pressed. Do the other burners work? Make sure the ignitor tip is clean and free from debris. Check battery to electronic ignition. Burner flame is yellow or orange and a gas odor is present Check the burner inlet for obstructions. Check the air shutter for proper adjustment. Low heat with knob on "HIGH" Burner will not light Is the fuel hose bent or kinked? Is there adequate gas supply available? If only one burner appears low, does the orifice or burner need cleaning? Are any other gas appliances at the location below normal rate? Is the air shutter too far open or closed? Is the gas supply or gas pressure low? Is there a spark at the thermocouple? Can you match light the burner using the flame parts? Burner lights, but will not hold flame once button is released Is the thermocouple kinked or bent away from the burner? Readjust to lay flat against burner. Is the safety valve button being depressed long enough? Hold button in until burner remains lit. Check for black spots on the infrared screen. If your grill rotisserie should fail to operate Is the electrical cord securely inserted in the electrical outlet? Is the circuit breaker open, or is a fuse blown? 31 Product Care