Viking VGSC530 Installation Instructions - Page 11

Standoff Bracket Removal DANGER FIRE HAZARD Backguards come standard with standoff brackets which provide a barrier between back of range and rear wall. These must be in place for adequate ventilation. The standoff brackets may only be removed if range is installed against a non-combustible wall. Final Installation 1 Note: Standoff brackets can only be removed if range is installed against a NON-COMBUSTIBLE wall. Please see the backguard install guide for instructions on how to remove the standoff brackets. 2 Install island trim. Attach with four screws provided. 3 Slide range into place. Be sure anti-tip bracket slides into the anti-tip opening. 4 Burner caps are packed in styrofoam top pack with the grates. Place burner on top of range. Place burner grate on top of burner cap and grate support. Note: Arrow on burner cap must be pointing towards back of range. (03.9/58"cm) Check that unit is level side to side and front to back. The side trim must be 3/8" (0.95 cm) above countertop. If unit is not level repeat steps 5-7 of "Leveling/Adjustments/Alignment" section. 20 Door Replacement and Adjustment 1 2 Reattach door to range. 3 Open door completely. Reattach hinge trim. 4 Remove pins from hole in hinges. 5 Close door. If the door needs to be adjusted, loosen hinge trim screws located in step 2. Adjust the screws located between the door and kickplate using a 5/32" hex head allen wrench. After adjustment, tighten hinge trim screws. 21