Viking VIPR161SS Installation Instructions - Page 6
Prepare The Downdraft, Cut Countertop Opening - motor
View all Viking VIPR161SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
VIKING RANGE CORPORATION Downdraft Ventilators PREPARE THE DOWNDRAFT Exterior Blower Installation The downdraft is shipped without a blower. Purchase a Model VEDV900 or VEDV1200 Exterior Blower and mount the 10" discharge plate to the downdraft as follows: 1. Place the downdraft on its back on a table of flat work surface. 2. Remove the 4 nuts and 2 clamp channels. 3. Remove 2 screws and the gear motor cover. 4. Carefully position the10" discharge plate under the bottom flange of the downdraft. 5. Connect motor plug. 6. Replace the gear motor cover and 2 sheet metal screws. 7. Replace the 2 clamp channels and start the 4 nuts, do not tighten. 8. Slide blower left of right to desired position. Use cover plate (supplied) to close up any open space. 9. Tighten 4 nuts to secure top of blower. Use additional screws (supplied) through bottom flange to secure bottom of discharge plate. CLAMP CHANNELS SCREWS GEARMOTOR COVER NUTS MOTOR PLUG 10" ROUND DISCHARGE PLATE COVER PLATE ADDITIONAL SCREWS BOTTOM FLANGE CUT COUNTERTOP OPENING All Units 1. Measure and cut the countertop opening for your width of cooktop and downdraft. Cooktop Width & Model 30" VECU 36" VECU VGSU102 VGSU162 30" VGRT * 36" VGRT * For use with Downdraft Models VIPR102SS VIPR162SS VIPR102SS VIPR162SS VIPR102RSS VIPR162RSS VIPR102RSS VIPR162RSS VIPR102RSS VIPR162RSS Cutout Dimensions A 28-3/4" B 20-1/4" C 27" D 2-1/4" E 7/8" F 7/8" 34-3/4" 20-1/4" 33" 2-1/4" 7/8" 7/8" 28-1/16" 18-3/4" 27" 3" --1-1/16" 34-1/4" 18-3/4" 33" 3" --1-1/4" 30" 24" 27" 2-3/4" 1-1/2" 1-1/2" * Must use island trim. Rear countertop trim (supplied with island trim) will be used in this installation. E F C C 36" 24" 33" 2-3/4" 1-1/2" 1-1/2" D 48" VGRT * VIPR182RSS 48" 24" 45" 2-3/4" 1-1/2" 1-1/2" F D VGSU102 & VGSU162 B Cooktops ONLY. B A 6 A