Viking VMOS201SS Flush-mount Kit for VMOS Microwave with 36 inch Trim Kit - In - Page 1
Viking VMOS201SS Manual
![]() |
View all Viking VMOS201SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
5/16" (8.77 mm) {" Cutout Opening Width 35-5/8" (904 mm) BUILT-IN TRIM KIT FLUSH MOUNTING TEMPLATE FOR CUSTOM SERIES MICROWAVE OVEN CENTER LINE 1. Align the Flush Mounting Template center line with the center of the cabinet. Align the Floor Line with the bottom of the cabinet at the desired height. Tape it in place. 2. Cut the cabinet opening along the three Cabinet Cutout Lines and the Floor Line. 3. Install two Side Spacers (see FIGURE 1) and two Bottom Spacers (see FIGURE 2) as specified in FIGURE 4. 4. Cut out the Side Spacer Templates (R and L) and align the indicated edge to the corresponding Side Spacer (see FIGURE 3). Be careful to align the Floor Line to the bottom edges of the Side Spacers. 5. Predrill two holes indicated "A" in Side Spacer - R with a / " drill bit. 6. Predrill two holes indicated "B" in Side Spacer - L with a / " drill bit. 7. Remove template from the cabinet. (2) bottom spacers 24-5/8" width 1" (25.4 mm) FIGURE 1 Side Spacer (2 required) Must protrude from edge of cabinet cutout towards center as shown. FIGURE 2 Bottom Spacers (2 required). 1-9/16" height {" Centerline to hole 17-3/16" (436.25 mm) {" Centerline to cutout 17-13/16" (452 mm) CABINET CUTOUT LINE The exhaust duct should be aligned left to right with the left and right edges of the bottom spacer. The front edge of the exhaust duct should be recessed from the edge of the bottom spacer by 5 mm in order for the unit to be flush with the front surface of the trim kit. The exhaust duct should be secured to the bottom spacer with Screw (C). 24-5/8" (625.5 mm) 4" (2) Bottom Spacer 22-1/16" (561.0 mm) 12-1/8" (308.45 mm) TOP VIEW 4" 1-15/16" (50.35 mm) FIGURE 3 Front of Cabinet (1) Bottom Spacer 1-15/16" (49.9 mm) Edges to align Side Spacer Templates (R and L) Side Spacer L Side Spacer R FIGURE 4 Bottom Spacers centered with cabinet cutout CABINET CUTOUT LINE 2-13/16" (71.1mm) FLOOR LINE OF CUTOUT OPENING TINSKB143MRR0 Height Distance Between Holes A 14-1/4" (361.8 mm) Cutout Opening Height 19-7/8" (504 mm) 5/16" (8.77 mm)
![](/manual_guide/products/viking-vmos201ss-flushmount-kit-vmos-microwave-36034-trim-kit-installation-instructions-8b56b93/1.png)