Viking VWCI1150GRSS Use and Care Manual - Page 9
Cleaning, Troubleshooting, CAUTION, WARNING
View all Viking VWCI1150GRSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
WDAARNNGIENRG Cleaning Cleaning To clean stainless steel exterior or interior surfaces, use a soft, non-abrasive stainless steel cleaner to wipe down these surfaces. Glass door panels can be cleaned using any standard glass cleaner available on the market today. To clean interior and exterior non-metallic surfaces and removable parts, wash with a mild solution of soap and lukewarm water with a little baking soda. Rinse and dry thoroughly. Avoid getting water on lights, controllers, fan motors, and unfinished wood wine rack faces. CDAAUNTGIOENR DO NOT use abrasive cleaners or cloths on any of the interior or exterior surfaces or removable parts. Condenser Cleaning WARNING For cleaning the condenser and other routine maintenance, shut off electricity to the unit. In all instances, you should clean the condenser area every three months. The condenser is located behind the kickplate. To clean the condenser remove the kickplate and use a soft bristle brush and vacuum to remove dust and lint. Avoid damaging or crushing the condenser fins or tubing. Upon completion, re-install the kickplate. FOR CYAOUUTRIOSANFETY Failure to clean the condenser could result in temperature loss or mechanical failure or damages. Clean this area every three months. DANGER 16 Troubleshooting Before Calling for Service If the unit appears to be malfunctioning, read through NORMAL OPERATION first. If the problem persists, check the TROUBLESHOOTING GUIDE. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem could be something, which can be solved without a service call. WARNING ELECTROCUTION HAZARD!! Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Problem No interior light Light stays on when door is closed Noise during operation Controller display is flashing "P1" Controller display is flashing "HA" Solution • Check to ensure bulb is tight. • Check to ensure bulb is not burned out. • Manual ON/OFF light switch is turned ON. • Check to ensure door switch is making contact with door. • Certain sounds are normal. Soft sounds from the compressor, fan motor and valves will be heard. • There is a thermostat probe failure. DANGER • The internal compartment temperature has exceeded the high temperature alarm preset value for over 30 minutes. • Check to ensure door is closed. • Check for door gasket seal. • Product was just installed. • Check to ensure condenser is clean. • Check to ensure kickplate is unobstructed. • Surrounding ambient temperature has changed dramatically. • Check to ensure interior light is OFF. 17