Viking VWCI5240GRSS Use and Care Manual - Page 12

Problem

Page 12 highlights

Troubleshooting Problem The refrigeration system runs for long periods of time Condensation forms inside the refrigerated compartments Solution • Check to ensure the condenser area is clean and free of obstructions. • Check to ensure the door has not beenopen for a long time or more frequent door openings aren't occurring. • Check to ensure warm product hasn't just been placed in the cabinet. • On hot days and in warm room temperatures the system will run long. • This is normal during high humidity and frequent door openings. • Check to ensure door is closed and sealing properly. Condensation forms on the outside of the unit • During periods of high humidity some condensation might appear on outside surfaces. The condensation will disappear when the humidity drops. Meanwhile, be sure doors are closing and sealing properly. If condensation persists, contact your local authorized servicer. When pressing the UP button, the display shows a "Hi" message followed by a temperature that does not match the set point. • If the UP button is pressed without pressing the SET button, the MAX stored temperature will be displayed. Press the UP button again or wait 5 seconds for the normal temperature to be displayed. To reset the MAX temperature, press and hold the SET button until the message "rSt" starts blinking. Release the SET button and the new stored value will be the current temperature. Frequent and/or extended door openingsmay cause a higher than expected MAX temperature. When pressing the DOWN button, • If the DOWN button is pressed without pressing the SET button, the the display shows a "Lo" message MIN stored temperature will be displayed. Press the DOWN button followed by a temperature that again or wait 5 seconds for the normal temperature to be displayed. To does not match the set point. reset the MIN temperature, press and hold the SET button until the message "rSt" starts blinking. Release the SET button and the new stored value will be the current temperature. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

12
Problem
Solution
The refrigeration system runs for
long periods of time
• Check to ensure the condenser area is clean and free of obstructions.
• Check to ensure the door has not beenopen for a long time or more
frequent door openings aren’t occurring.
• Check to ensure warm product hasn’t just been placed in the cabinet.
• On hot days and in warm room temperatures the system will run long.
Condensation forms inside the
refrigerated compartments
• This is normal during high humidity and frequent door openings.
• Check to ensure door is closed and sealing properly.
Condensation forms on the
outside of the unit
• During periods of high humidity some condensation might appear on
outside surfaces. The condensation will disappear when the humidity
drops. Meanwhile, be sure doors are closing and sealing properly.
If
condensation persists, contact your
local authorized servicer.
When pressing the UP button, the
display shows a “Hi” message
followed by a temperature that
does not match the set point.
• If the UP button is pressed without pressing the SET button, the MAX
stored temperature will be displayed. Press the UP button again or wait
5 seconds for the normal temperature to be displayed. To reset the
MAX temperature, press and hold the SET button until the message
“rSt” starts blinking. Release the SET button and the new stored value
will be the current temperature. Frequent and/or extended door
openingsmay cause a higher than expected MAX temperature.
When pressing the DOWN button,
the display shows a “Lo” message
followed by a temperature that
does not match the set point.
• If the DOWN button is pressed without pressing the SET button, the
MIN stored temperature will be displayed. Press the DOWN button
again or wait 5 seconds for the normal temperature to be displayed. To
reset the MIN temperature, press and hold the SET button until the
message “rSt” starts blinking. Release the SET button and the new
stored value will be the current temperature.
Troubleshooting