Viking VWH4878TSS Installation Instructions - Page 24

3 4 5/16" nut driver Run duct work down to bottom edge of duct cover/soffit and secure in place. Make sure the duct does not stick down past the cover. To install ventillation kit refer to ventillation kit installation instructions. Attach canopy to duct cover/soffit. Seal top of hood to duct with aluminum tape. 5 1 6 1 2 3 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 7 1 3 2 Slide spacer front over front lip. Push spacer rear up, then slide back over rear lip. NOTE: Number of spacers and baffles may vary by model. 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 46 Service & Registration Service & Parts Only authorized replacement parts may be used in performing service on the appliance. Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified technician. Record the following information indicated below. You will need it if service is ever required. The serial number and model number for your appliance are located on the identification plate mounted on the inside of the hood canopy. Model number Serial number Date of purchase Date installed Dealer's name Address 47