Viper 1002 Owner Manual - Page 21

one-time bypass - alarm system

Get Viper 1002 PDF manuals and user guides View all Viper 1002 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

To enter or exit Valet Mode using the remote control: 1. Open any vehicle door. 2. Press . 3. Press or . 4. Press again. The status LED will light solidly if you are entering Valet Mode, and it will go out if you are exiting Valet Mode. ➜ one-time bypass This feature (if programmed On) stops the alarm from arming or activating any outputs that are programmed to activate when the alarm is armed. One-time bypass will defeat the following actions: Passive arming: If programmed ON the alarm will not arm itself. If the remote is used to arm the alarm after exiting the vehicle: Window roll up: If programmed ON this output will not activate. Linked Auxiliary Outputs: If programmed to activate on arm, they will not activate. To activate one-time bypass: 1. After parking turn the ignition off. 2. Turn the ignition On for more than 1-second and less than 3-seconds and then turn Off. 3. The siren will chirp once to indicate one-time bypass has been activated. 16 © 2006 directed electronics

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
16
© 2006 directed electronics
To enter or exit Valet Mode using the remote control:
1.
Open any vehicle door.
2.
Press
.
3.
Press
or
.
4.
Press
again.
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
one-time bypass
This feature (if programmed On) stops the alarm from arming or
activating any outputs that are programmed to activate when the
alarm is armed.
One-time bypass will defeat the following actions:
Passive arming: If programmed ON the alarm will not arm
itself.
If the remote is used to arm the alarm after exiting the vehicle:
Window roll up: If programmed ON this output will not
activate.
Linked Auxiliary Outputs: If programmed to activate on
arm, they will not activate.
To activate one-time bypass:
1.
After parking turn the ignition off.
2.
Turn the ignition On for more than 1-second and less than
3-seconds and then turn Off.
3.
The siren will chirp once to indicate one-time bypass has
been activated.
➜