Viper 125HF Owner Manual - Page 15

To perform Valet Take-Over: 1. Before turning off the engine, press and release and on the transmitter (or press and release the optional Momentary switch). 2. Turn the ignition key to the OFF position. (The engine will stay running.) 3. The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous Remote Start section for a complete list of shut-down inputs.) NOTE: This feature will not work if the brake pedal is being pressed. Using Remote Start with Factory Remote Systems This remote start system is also designed to interface with most original equipment from manufacturer (OEM) factory remote systems. The Remote Start/Valet Take-Over sequence can be programmed to initiate with one to three (1-3) presses of one of the OEM transmitter buttons. Consult with your dealer to determine the transmitter button and the number of presses (1-3) that have been programmed for this sequence. Spaces are provided below for writing in the button and number of button presses. OEM transmitter button used for Remote Start/Valet Take-Over sequence Number of presses required to initiate Remote Start/Valet Take-Over sequence 12 © 1999 Directed Electronics, Inc.