Viper 3105V Owner Manual - Page 24

Disarming the VRS

Get Viper 3105V PDF manuals and user guides View all Viper 3105V manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Disarming the VRS Take the time to familiarize yourself with the VRS triggering sequence and the disarm procedure. It is important to recognize and identify the VRS trigger sequence and know how to disarm it in case of accidental activation. Once the VRS is armed, it does not disarm automatically. You must disarm it the next time you operate the vehicle. You must disarm it with one of the following procedures: If the system has not entered the triggered sequence (siren has not started chirping): 1. Turn the ignition on. 2. Press on the remote control for 1 second. The lights flash and the siren chips. If the system has entered the triggered se- quence (siren has begun chirping), pressing the disarm button of the transmitter will not disarm VRS. To disarm the VRS during a VRS trigger sequence: 3. Turn the ignition on. 4. Press the Valet button the pre-programmed number of times to disarm the VRS system. If the VRS has begun its chirping sequence, the ignition must be turned off, then On, to disarm. If you are driving the vehicle, pull over to a safe place and follow the triggered sequence disarm procedure. Note: The unit responds to 1 to 5 valet button presses to disarm the VRS (factory setting is 1 press). Check with your installer to determine the setting you want. © 2012 Directed. All rights reserved. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
21
© 2012 Directed. All rights reserved.
Disarming the VRS
Take the time to familiarize yourself with the VRS triggering sequence
and the disarm procedure. It is important to recognize and identify the
VRS trigger sequence and know how to disarm it in case of acciden-
tal activation.
Once the VRS is armed, it does not disarm automatically. You must
disarm it the next time you operate the vehicle. You must disarm it with
one of the following procedures:
If the system has not entered the triggered sequence (siren has not
started chirping):
1.
Turn the ignition on.
2. Press
on the remote control for 1 second. The lights flash
and the siren chips. If the system has entered the triggered se-
quence (siren has begun chirping), pressing the disarm button of
the transmitter will not disarm VRS.
To disarm the VRS during a VRS trigger sequence:
3.
Turn the ignition on.
4.
Press the Valet button the pre-programmed number of times to
disarm the VRS system.
If the VRS has begun its chirping sequence, the ignition must be
turned off, then On, to disarm. If you are driving the vehicle, pull
over to a safe place and follow the triggered sequence disarm
procedure.
Note:
The unit responds to 1 to 5 valet button presses to disarm
the VRS (factory setting is 1 press). Check with your installer to
determine the setting you want.