Viper 4115V Owner Manual - Page 9
Remote Programming, Programming Options - valet button
View all Viper 4115V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Remote Programming 1. Turn key to the ON position 2. Within 10 seconds, press and release Valet button one time. 3. Within 10 seconds, press and hold the Valet button. The LED on the mod- ule flashes one time and the horn honks (if connected) to confirm entry into remote programming. Do not release the valet button. 4. Press the button on the remote control. The horn honks to confirm the remote has been programmed. 5. Release the Valet button. 6. Turn the key to the Off position. The horn sounds one long honk to confirm that remote programming has been exited. The programming routine exits if any of the following occurs: • The ignition is turned off • There is no activity for 30 seconds • The Valet button is pressed too many times Programming Options Programming options control your system's normal operational set-up. Most options do not require additional parts, but some may require installation labor. The following is a list of the programmable options, with the factory settings in bold. • Your system can be programmed to allow the vehicle to run for up to 60 minutes when remote started. Can be set up to minute increments by your installer. • Parking lights flashing or constant. Your system can be programmed to flash or turn on the parking lights constantly during the entire remote start operation. 8 © 2012 Directed. All rights reserved.