Viper 560XV Owner Manual - Page 30
disarming diagnostics, system status chirps
View all Viper 560XV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
the system was armed, until that input ceases. Three seconds after that input ceases, the security system will resume normal monitoring. For example, if your vehicle has an interior light exit delay and you arm your security system before the interior light turns off, you may hear a second Bypass Notification chirp. Once the light turns off, however, the security system resumes normal monitoring. note: Bypass Notification does not occur when the system is in Silent Mode or if the notification chirps have been programmed off by the installer. ➜ disarming diagnostics Extra chirps that are heard when disarming the system are the Tamper Alert. If four chirps are heard when disarming the system, then the security system was triggered in your absence. If five chirps are heard when disarming the system, a zone was triggered so many times that the Nuisance Protection® Circuitry has bypassed that zone. In either case, the status LED will indicate which zone was involved (see Table of Zones section). The security system will retain this information in its memory and chirp four or five times each time it is disarmed, until the next time that the ignition is turned on. ➜ system status chirps The siren will chirp when arming/disarming the system. The pattern of chirps will audibly report the system's status as described below. © 2005 directed electronics-all rights reserved 27