Vizio SB4451-C0 Quickstart Guide (English) - Page 19
Subwoofer, Surnd, TruVol, Night, AV Delay, Spkr Test
View all Vizio SB4451-C0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Function Surround Balance Surr Bal LED Behavior Two center LEDs indicate Surround Balance is centered. Subwoofer Levels Subwoofer Two center LEDs indicate Subwoofer level 0. Surround On/Off Surnd Surround On Surround Off DTS TruVolume On/Off TruVol TruVolume On TruVolume Off Night Mode On/Off Night Night Mode On Night Mode Off AV Delay AV Delay LED at the bottom indicates no delay. Speaker Test Spkr Test - Description Press the Next/Previous button to increase/decrease the surround balance level on each side. The LED indicators will move to the top with balance levels to the right and down with balance levels to the left. Press the Next/Previous button to increase/decrease the level of the subwoofer. The LED indicators will move to the top with increasing levels and to the bottom with decreasing levels. Press the Next/Previous button to enable/disable surround sound. When enabled (On), all inputs will produce 5.1 surround sound. When disabled (Off), the satellite speakers will be disabled. Press the Next/Previous button to enable/disable TruVolume. When enabled (On), TruVolume provides a consistent and comfortable volume level for a more enjoyable listening experience. Press the Next/Previous button to enable/disable Night Mode. When enabled (On), the Sound Bar will lower bass frequency levels to provide a more quiet environment (ideal for apartment living and homes with sleeping children). Press the Next/Previous button to increase/decrease the amount of audio delay. The LED indicators will move to the top with increasing audio delay levels. Press the Play/Pause button to activate the speaker test function. A voice will begin calling out each speaker beginning with left front. (Left Front, Center, Right Front, Right Rear, Left Rear, and Subwoofer-white noise) If any of these are missing, check the connection and run the speaker test function again. 19