Vtech 2-Line Accessory Handset for use with the DS6151 User Manual (DS6101 Use - Page 6
Battery charging - use with the
View all Vtech 2-Line Accessory Handset for use with the DS6151 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Getting started Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 8 for battery operating times. If the screen is blank, you need to charge the handset without interruption for at least 10 minutes to give the handset enough charge to use the telephone for a short time. The handset beeps and shows Low battery. If you are on a call in low battery mode, the handset beeps every minute. The following table summarizes the battery charge indicators and actions to take. Battery indicators The screen is blank. The screen shows Place handset in charger and flashes. The screen shows Low battery and flashes. The screen shows HANDSET. Battery status Battery has no charge and the handset cannot be used. Battery has very little charge and the handset cannot be used. Battery has enough charge to be used for a short time. Battery is charged. Action Charge without interruption until the screen shows Low battery (at least 10 minutes). Charge without interruption until the screen shows Low battery (at least four minutes). Charge without interruption until the screen shows HANDSET (at least 30 minutes). To keep the battery charged, place it in the telephone base when not in use.