Vtech 2428 User Guide - Page 7

Table/Desk Installation, Charge the handset battery., Check for dial tone, PHONE, Set the dial mode.

Get Vtech 2428 - VT Cordless Phone PDF manuals and user guides
UPC - 735078001399
View all Vtech 2428 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

INSTALLATION NOTE: Install the Base Unit away from electronic equipment, such as personal computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture. Table/Desk Installation CONNECT THE POWER CORD Standard electrical outlet CONNECT THE TELEPHONE LINE CORD Modular telephone jack 4. Charge the handset battery. Place the handset in the base. Charge the battery for at least 12 hours the first time. 5. Check for dial tone After the batteries are charged, connect the modular telephone cord between a live phone jack and the jack located on the bottom of the Base Unit. Pick up the Handset and press PHONE. You should hear a dial tone. 6. Set the dial mode. If you have touch tone service, the phone is ready to use as soon as the batteries are charged. If you have dial pulse (rotary) service, you'll need to change the dial mode. • Press PROG/CHAN on the handset to enter programming mode. • Press or until the screen displays DIAL MODE: and the currently selected mode. • Press SELECT. The current setting blinks. • Press to select TONE or PULSE . • Press SELECT, to save the displayed mode. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
NOTE:
Install the Base Unit away from electronic equipment, such as personal
computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or
moisture.
Table/Desk Installation
±²³³´±µ¶µ·´¶¸²¹´º¶±²º»
±²³³´±µ¶µ·´
µ´¼´¸·²³´¶¼½³´¶±²º»
¾¿ÀÁÂÀöÄÅÄÆ¿ÃÇÆÀŶÈÉ¿ÅÄ¿
±²³´µ¶·¸¹ºµº»¼²½º¸¾¶¿À
4.
Charge the handset battery.
Place the handset in the base. Charge the battery for at least 12 hours the first time.
5.
Check for dial tone
After the batteries are charged, connect the modular telephone cord between a live phone jack
and the jack located on the bottom of the Base Unit.
Pick up the Handset and press
PHONE
.
You should hear a dial tone.
6.
Set the dial mode.
If you have touch tone service, the phone is ready to use as soon as the batteries are charged.
If you have dial pulse (rotary) service, you’ll need to change the dial mode.
•
Press
PROG/CHAN
on the handset to enter programming mode.
•
Press
or
until the screen displays
DIAL MODE
:
and the currently selected mode.
•
Press
SELECT
. The current setting blinks.
•
Press
to select
TONE
or
PULSE
.
•
Press
SELECT
, to save the displayed mode.
INSTALLATION
4