Vtech A100D Quick Installation Guide - Page 2

Connect Adjust angle A100M Connect to the port on your IP phone. 4P4C AUDIO A100D Important safety instructions • This device is for indoor use only! NOT FOR OUTDOOR USE! • Do not install the device in rooms with high humidity (for example, in bathrooms, laundry rooms, damp basements). • Do not immerse the device in water and do not spill or pour liquids of any kind onto or into the device. • Do not use the device during thunderstorms. Lightning striking the power grid may cause electric shocks. • Warning: The earpiece contains a magnet, and it may attract small dangerous objects such as needles or pins. Please ensure before each use that no such objects are present. • Do not use the telephone to report a gas leak in the vicinity of the leak. SAVE THESE INSTRUCTIONS IMPORTANTES MESURES DE SÉCURITÉ Certaines mesures de sécurité doivent être prises pendant l'utilisation de matérial téléphonique afin de réduire les risques d'incendie, de choc électrique et de blessures. En voici quelquesunes: 1. Ne pas utiliser l'appareil près de l'eau, p.ex., près d'une baignoire, d'un lavabo, d'un évier de cuisine, d'un bac à laver, dans un sous-sol humide ou près d'une piscine. 2. Éviter d'utiliser le téléphone (sauf s'il s'agit d'un appareil sans fil) pendant un orage électrique. Ceci peut présenter un risque de choc électrique causé par la foudre. 3. Ne pas utiliser l'appareil téléphonique pour signaler une fuite de gaz s'il est situé près de la fuite. CONSERVER CES INSTRUCTIONS Le casque connecté à un équipement téléphonique doit être conforme à la norme UL 60950-1: 2007 Ed.2 / CSA C22.2 # 60950-1: 2007 Ed.2 Standards conformance This device meets US health, safety, and environmental standards. Unauthorized opening, changing, or modifying the device will cause the warranty to lapse and may also result in the loss of FCC conformity. In case of malfunction contact authorized service personnel, your seller or VTech. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. • Connector: - Quick Release (QR) modular plug - Quick Release (QR) coil cord to 4P4C phone jack The Headset connected to telephony equipment shall comply UL 60950-1:2007 Ed.2 / CSA C22.2#60950-1:2007 Ed.2 This device complies with IC standard. Cleaning To clean the device, use an anti-static cloth. Please avoid cleaning liquids as they might damage the surface or internal electronics of the device. Customer service For customer service, visit our website at businessphones.vtech.com or call 1 (800) 595-9511. In Canada, call 1 (800) 267-7377. Disclaimer Phone manufacturers might change their headset interface from time to time. If the designated cable does not work, try the other cables. If the other cables do not work either, contact our customer services. Specifications are subject to change without notice. © 2018 VTech Communications, Inc. All rights reserved. 09/18. A100M_A100D_CIB_V2