Vtech CL84100 User Manual - Page 13
Battery installation and charging, Place in charger, Step 1, THIS SIDE UP - cordless
View all Vtech CL84100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Getting started Battery installation and charging Install the cordless handset battery as shown below. Once you have installed the battery, the screen indicates the battery status (see table below). If necessary, place the handset in the handset charger to charge the battery. For best performance, keep the handset in the handset charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 91 for battery operating times. If the screen shows Place in charger and flashes, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. The following table summarizes the battery charge indicators and actions to take. Battery indicators Battery status Action The screen is blank or shows Place in charger and (flashing). Battery has no or very little charge. The handset cannot be used. Charge without interruption until the screen shows Low battery or HANDSET X (at least 30 minutes). The screen shows Low battery and (flashing). Battery has enough charge to be used for a short time. Charge without interruption until the screen shows HANDSET X (at least 30 minutes). The screen shows HANDSET X. Battery is charged. To keep the battery charged, place it in the handset charger when not in use. NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute. Step 1 Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label. Insert the supplied battery with the label THIS SIDE UP facing up as indicated. Step 2 Align the cover flat against the battery compartment, then slide it upwards until it clicks into place.