Vtech CS6529-3 Abridged User Manual - Page 3

Battery installation Install the battery as shown below. . Plug the battery connector securely into the socket. 2. Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment. 3. Slide the battery compartment cover 4. Place the handset in the telephone towards the center of the handset until base or charger to charge. it clicks into place. CHARGE light remains on when charging. Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 11 hours of continuous charging. Battery indicators Battery status Action The screen is blank, or displays Put in charger and flashes. The screen displays Low battery and flashes. The battery has no or very little charge. The handset cannot be used. The battery has enough charge to be used for a short time. Charge without interruption (at least 30 minutes). Charge without interruption (about 30 minutes). The screen displays HANDSET X. The battery is charged. To keep the battery charged, place it in the telephone base or charger when not in use. Wall mounting (optional) To mount your telephone on a wall: . Remove the telephone line cord from the telephone wall jack, and the telephone base power adapter from the electrical outlet (if necessary). 2. Position the telephone base against the wall mount bracket with the extended tabs marked B on top. Insert the extended tabs marked B on the wall mount bracket into the slots marked B on the back of the telephone base. Push the telephone base down until it clicks securely. 3. Route the telephone line cord through the hole on the wall mount bracket and plug it into the telephone wall jack. Route the power cord out of the telephone base and plug it into an electrical outlet not controlled by a wall switch. 4. Align the holes on the bracket with the standard wall plate and slide the bracket down until it locks securely. Bundle the telephone line cord and power adapter cord neatly with twist ties.