Vtech Pop-a-Balls Pop & Count Ball Pit User Manual - Page 5

GETTING STARTED Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Locate the battery cover on the back of the electronic tree activity panel. Use a screwdriver to loosen the screw and open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 3 new AAA batteries following the diagram inside the battery box. Replace the battery cover and tighten the screw to secure. WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children. ATTENTION : Les piles ou accumulateurs doivent être installés par un adulte. Tenir les piles ou accumulateurs hors de portée des enfants. IMPORTANT: BATTERY INFORMATION • Insert batteries with the correct polarity (+ and -). • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. • Only batteries of the same or equivalent type as recommended are to be used. • Do not short-circuit the supply terminals. • Remove batteries during long periods of non-use. • Remove exhausted batteries from the toy. • Dispose of batteries safely. Do not dispose of batteries in fire. 55