Vtech Switch & Go Hatch & Roaaar Egg Triceratops Race Car User Manual - Page 4
Getting Started
View all Vtech Switch & Go Hatch & Roaaar Egg Triceratops Race Car manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
GETTING STARTED Exit Try-Me Mode: The product is in try-me mode in the packaging. To exit try-me mode, just slide the Off/Dino Mode/Vehicle Mode Switch from Vehicle mode to Dino mode/Off. Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Find the battery cover located on the bottom of the unit. Use a screwdriver to loosen the screw, and then open the battery cover. 3. Remove the old battery by pulling up on one end of the battery. 4. Install 1 new AAA battery following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.) 5. Replace the battery cover and tighten the screw to secure. WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children. ATTENTION : Les piles ou accumulateurs doivent être installés par un adulte. Tenir les piles ou accumulateurs hors de portée des enfants. 4