Vtech Switch & Go T-Rex Drift Car User Manual - Page 4
Getting Started
View all Vtech Switch & Go T-Rex Drift Car manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
GETTING STARTED Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Find the battery cover on the back of the unit, use a screwdriver to loosen the screw and then open the battery box. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended). 5. Replace the battery cover and tighten the screw to secure. Note: If there is no response when the dino is switched on, please install brand new batteries and try switching the dino on again. WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children. ATTENTION : Les piles ou accumulateurs doivent être installés par un adulte. Tenir les piles ou accumulateurs hors de portée des enfants. 4