Vtech Switch & Go T-Rex Race Car User Manual - Page 4
Instructions
View all Vtech Switch & Go T-Rex Race Car manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTRUCTIONS Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Find the battery cover located on the bottom of the unit and use a screwdriver to loosen the screw, then open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 2 new AA size (LR6/AM-3) batteries following the diagram inside the battery box. (The use of new alkaline batteries is recommended for maximum performance.) 5. Replace the battery cover and tighten the screw to secure. WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children. ATTENTION : Les piles ou accumulateurs doivent être installés par un adulte. Tenir les piles ou accumulateurs hors de portée des enfants. 4