Vtech T2455 User Manual - Page 33

Additional Information

Get Vtech T2455 - 2.4GHz Dual Handset Cordless Phone System PDF manuals and user guides
UPC - 735078006486
View all Vtech T2455 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

In Case of Difficulty You hear noise in the Handset, and none of the keys or buttons work • Make sure the power cord is plugged in. Common cure for electronic equipment If the unit does not seem to be responding normally, then try putting the Handset in the cradle. If it does not seem to respond, do the following (in the order listed): 1. Disconnect the power to the Base. 2. Disconnect the Handset battery. 3. Wait a few minutes. 4. Connect power to the Base. 5. Re-install the battery pack. 6. Wait for the Handset to re-establish its link with the Base. To be safe, allow up to one minute for this to take place. Your answering system is not recording messages • Make sure system is turned on (the ON/OFF key is illuminated). • Make sure Announce Only feature is set to OFF. You cannot hear recorded messages • Using the Base volume control, raise the volume to a comfortable listening level. CL is flashing in the Base Message Window Display • You need to set the day and time. Refer to the section on Set the Clock in this User's Manual. Additional Information 33 91-005650-040-000t2455.p65 33 7/21/2004, 3:52 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
33
Additional Information
You hear noise in the Handset, and none of the keys or buttons work
•
Make sure the power cord is plugged in.
Common cure for electronic equipment
If the unit does not seem to be responding normally, then try putting the Handset
in the cradle. If it does not seem to respond, do the following (in the order listed):
1.
Disconnect the power to the Base.
2.
Disconnect the Handset battery.
3.
Wait a few minutes.
4.
Connect power to the Base.
5.
Re-install the battery pack.
6.
Wait for the Handset to re-establish its link with the Base. To be safe, allow up
to one minute for this to take place.
Your answering system is not recording messages
•
Make sure system is turned on (the
ON/OFF
key is illuminated).
•
Make sure
Announce Only
feature is set to
OFF
.
You cannot hear recorded messages
•
Using the Base volume control, raise the volume to a comfortable listening
level.
CL is flashing in the Base Message Window Display
•
You need to set the day and time. Refer to the section on
Set the Clock
in this
User’s Manual.
In Case of Difficulty
91-005650-040-000t2455.p65
7/21/2004, 3:52 PM
33