Vtech TD45270194 User Manual - Page 3

Battery installation Install the battery as shown below. 1 Plug the battery connector securely into the socket. 2 Place the battery with the wires inside the battery compartment. 3 Slide the battery compartment 4 Place the handset in the cover towards the center of the telephone base or charger handset until it clicks into place. to charge. CHARGE light remains on when charging. CANCEL If the handset will not be used for a long period of time, disconnect and remove the battery to prevent any possible leakage. Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging. Refer to the online user's manual for battery operating times. Battery indicators The screen is blank, or displays Place in charger and flashes. The screen displays Low battery and flashes. The screen displays HANDSET X and Battery status Battery has very little or no charge. The handset cannot be used. Battery has enough charge to be used for a short time. Battery is charged. Action Charge without interruption (at least 30 minutes). Charge without interruption (about 30 minutes). To keep the battery charged, place it in the telephone base or charger when not in use. If you place the handset in the telephone base or charger without plugging in the battery, the screen displays No battery.