Vtech Three Handset Expandable Cordless Phone System with Digital Answering Syst - Page 1

Quick start guide for models LS6325/LS6325-2/LS6325-3/ LS6325-4/LS6325-5/LS6326-5 Install the telephone base and charger(s) Install the telephone base and charger(s) as shown below. Telephone wall jack If you have DSL high speed Internet service, a DSL filter (not included) is required. Telephone line cord Telephone base power adapter Charger adapter Electrical outlet not controlled by a wall switch Battery installation and charging Install the battery as shown below. After installing the battery, you may be able to make and receive short calls. For best performance, charge the handset battery for at least 16 hours before use. 1 2 If the battery Plug the battery compartment cover is on connector securely the handset, press on the into the socket inside indentation and slide the the handset battery cover to remove. compartment, matching the color-coded label. 3 Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment. 4 Align the cover flat against the battery compartment, then slide it towards the center of the handset until it clicks into place. Make, answer and end a call Make a call 1. Press /FLASH or . You hear a dial tone. 2. Dial the number. Make a predial call 1. Dial the number. 2. Press /FLASH or . Answer a call Press /FLASH, or any of the dialing keys (0-9, #, TONE ). End a call Press OFF/CLEAR or put the handset in the telephone base or charger. Push to talk (PTT) You can directly broadcast messages from one handset to the speakerphone of one or all other handsets. Any handset you call can respond by pressing PUSH TO TALK to begin a two-way communication. When the connection is made, both the caller and the destination handsets display Press and hold [PTT] to talk and beep once. Only one handset can be talk at a time. To do so, press and hold PUSH TO TALK. For complete PTT instructions, please refer to your user's manual. Telephone base Charger • Use only the power adapters and batteries supplied with your VTech telephone. • For complete feature instructions, please refer to your user's manual. 5 Charge the handset by placing it in the telephone base or charger. The CHARGE light is on when the handset charges. CHARGE light