Vtech Toddler Tech Laptop User Manual - Page 4

Getting Started

Page 4 highlights

GETTING STARTED Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Find the battery cover located on the back of the laptop, use a screwdriver to loosen the screw and then open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 3 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.). 5. Replace the battery cover and tighten the screw to secure. WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children. ATTENTION : Les piles ou accumulateurs doivent être installés par un adulte. Tenir les piles ou accumulateurs hors de portée des enfants. IMPORTANT: BATTERY INFORMATION • Insert batteries with the correct polarity (+ and -). • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. • Only batteries of the same or equivalent type as recommended are to be used. • Do not short-circuit the supply terminals. 44

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11

4
4
GETTING STARTED
Battery Removal and Installation
1.
Make sure the unit is turned
Off
.
2.
Find the battery cover located on the
back of the laptop, use a screwdriver
to loosen the screw and then open
the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4.
Install 3 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box.
(For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.).
5.
Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
IMPORTANT: BATTERY INFORMATION
Insert batteries with the correct polarity (+ and -).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
Only batteries of the same or equivalent type as recommended
are to be used.
Do not short-circuit the supply terminals.