Vtech Two Handset DECT 6.0 Expandable Cordless Phone with One DECT 6.0 Cordless - Page 76
Deregister handsets/headsets
View all Vtech Two Handset DECT 6.0 Expandable Cordless Phone with One DECT 6.0 Cordless Headset Push-To-Talk & HD Audio manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Appendix Deregister handsets/headsets If you want to replace a handset or headset, or reassign the designated handset number of a registered handset, you must deregister all handsets and headsets that are registered to the telephone base. Then register each handset and headset individually. To make deregistration easier, read all of the instructions on this page before you begin. Make sure that all handsets are out of the telephone base and handset chargers before you begin deregistration. To deregister all handsets and headsets: 1. Press and hold /FIND HANDSET on the telephone base for about 10 seconds until the IN USE light on the telephone base turns on and starts flashing. 2. Press and release /FIND HANDSET again. You must press /FIND HANDSET while the IN USE light is still flashing. The IN USE light flashes for approximately seven seconds. 3. The deregistration process takes about 10 seconds to complete. All handsets show Put HS on BASE to register and all headset lights flash slowly and alternately in red and blue. If the deregistration process is successful, you hear "Not registered" through the headset earpiece when you press on the headset. If deregistration fails, you may need to reset the telephone and try again. To reset: 1. Pick up the registered handset. Press /FLASH and then press OFF/CANCEL. Place the handset in the telephone base. 2. Pick up the registered headset and press the RESET inset button with a paper clip or similar object. -ORUnplug the power from the telephone base, then plug it back in. You cannot deregister all handsets and headsets if any other system handset or headset is in use. 72