Waring CTS1000B Instruction Manual - Page 6

Caution: Do Not Attempt To Clear The Jam

Get Waring CTS1000B PDF manuals and user guides View all Waring CTS1000B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

9. When complete, toast will slide down bread chute into the toast drawer. 10. If toast is too light or too dark, adjust the power control and speed control until you reach your desired shade. Standby Function 11. During long periods of inactivity, the standby position on the function control knob can be used to decrease the unit to ¼ power. This is done to save power and energy during idle periods and extend the life of the toaster's components. When full power is needed once again, select desired function and allow 3 to 4 minutes for unit to heat up again. The green indicator light will illuminate when unit is ready to toast. IMPORTANT Your READY/HOT indicator light will illuminate when the toaster is hot. Once turned off, the light will remain on until the unit has cooled off. Keep the unit plugged in until the light has shut off and the unit is cool. Do not clean the unit until it has completely cooled off, the READY/HOT light has turned off, and the unit has been unplugged. Clearing a Toaster Jam • WARNING: Never insert hands into the toasting chamber to clear a jam. Serious injury may result. • WARNING: Never use a plastic object to clear a jam. If the toaster has not cooled down completely, damage to the toaster may result. • Switch toaster to the Off position, allow the toaster to cool completely and unplug. CAUTION: DO NOT ATTEMPT TO CLEAR THE JAM UNTIL THE TOASTER HAS COOLED THOROUGHLY. • To clear jam, remove reflector/crumb tray and, using a long object, preferably made of wood, dislodge object causing jam. 9 Cleaning Instructions • CAUTION: Switch toaster off, wait for READY/HOT switch to turn off, then unplug. Do not touch hot surfaces until the unit has cooled. • IMPORTANT: Do not clean your conveyor toaster using abrasive cleaners or pads. This will scratch and dull the surface of your unit. • CAUTION: Do not spray, rinse or submerge the toaster in any liquid. Excessive moisture in the unit will cause a severe electrical hazard and may otherwise damage the toaster. • Wipe the exterior of the toaster with a damp sponge or cloth soaked in hot or warm detergent water. Wipe with a clean, damp cloth to remove excess detergent and then wipe to dry the toaster. • Remove the reflector/crumb tray, toast drawer and wire bread feeder from the unit and empty them. Wash them in warm detergent water and rinse them. Dry tray, drawer and rack thoroughly. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
9.
When complete, toast will slide down bread chute into the
toast drawer.
10.
If toast is too light or too dark, adjust the power control and
speed control until you reach your desired shade.
Standby Function
11.
During long periods of inactivity, the standby position on
the function control knob can be used to decrease the unit
to ¼ power. This is done to save power and energy during
idle periods and extend the life of the toaster’s components.
When full power is needed once again, select desired
function and allow 3 to 4 minutes for unit to heat up again.
The green indicator light will illuminate when unit is ready to
toast.
IMPORTANT
Your READY/HOT indicator light will illuminate when the toaster
is hot. Once turned off, the light will remain on until the unit has
cooled off. Keep the unit plugged in until the light has shut off and
the unit is cool.
Do not clean the unit until it has completely cooled off,
the READY/HOT light has turned off, and the unit has been
unplugged.
Clearing a Toaster Jam
•
WARNING:
Never insert hands into the toasting chamber to
clear a jam. Serious injury may result.
•
WARNING:
Never use a plastic object to clear a jam.
If the toaster has not cooled down completely, damage
to the toaster may result.
•
Switch toaster to the
OFF position, allow the toaster to cool
completely and unplug.
CAUTION: DO NOT ATTEMPT TO CLEAR THE JAM
UNTIL THE TOASTER HAS COOLED THOROUGHLY.
•
To clear jam, remove reflector/crumb tray and, using a long
object, preferably made of wood, dislodge object causing jam.
9
10
Cleaning Instructions
•
CAUTION:
Switch toaster off, wait for READY/HOT switch to
turn off, then unplug. Do not touch hot surfaces until the unit
has cooled.
•
IMPORTANT:
Do not clean your conveyor toaster using
abrasive cleaners or pads. This will scratch and dull the
surface of your unit.
•
CAUTION:
Do not spray, rinse or submerge the toaster
in any liquid. Excessive moisture in the unit will cause a
severe electrical hazard and may otherwise damage
the toaster.
•
Wipe the exterior of the toaster with a damp sponge or cloth
soaked in hot or warm detergent water. Wipe with a clean,
damp cloth to remove excess detergent and then wipe to dry
the toaster.
•
Remove the reflector/crumb tray, toast drawer and wire bread
feeder from the unit and empty them. Wash them in warm
detergent water and rinse them. Dry tray, drawer and rack
thoroughly.