Waring PJE401 Instruction Booklet - Page 4

Disassembling Important: Juice extractor should be unplugged from outlet when disassembling. • After removing your new juice extractor from the box, you may want to familiarize yourself with the parts by disassembling the unit and washing the top parts (pusher, cover, clutch, cutter blade, strainer basket, and juice collector bowl, see Figure 1). • With juice extractor facing you (spout front), put your hands on both sides of the cover. Using the side arms for leverage, push back with your left hand and pull forward with your right, turning the cover clockwise. This will disengage the cover from the spring clips and disengage the lid safety interlock. • Look into juice extractor and remove clutch by unscrewing counterclockwise. • Lift out cutter blade. • Lift out strainer basket. • Lift off bowl. Assembling • Place bowl on motor base housing and place the spout facing front between the two raised projections on the motor base housing. • Place strainer basket inside the bowl over the hex drive. Be certain the strainer basket sits flat. • Place cutter blade inside strainer basket with teeth up. • Tighten clutch finger until it is tight or snug. • If using disposable filter, insert it flat against the holes around the inside of the strainer basket. Once the juice extractor is running, centrifugal force will push the filter into perfect position. • Place cover on bowl with feed chute at the rear, grip the sides of the lid firmly and turn counter clockwise to engage the spring clips and the safety interlock. • IMPORTANT NOTE: The juice extractor will not operate until the cover is properly assembled to the unit. 3