Waring TG15 Instruction Booklet - Page 4

How To Assemble Containers with Removable Blades Always wash and rinse container prior to initial use. 1. Before starting, make sure that the blender cord is unplugged and that the switch is in the OFF position. 2. Refer to Figure 1. The following points are important to note when putting together the container assembly: • Container gasket must be placed between blade assembly and container. • Collar must be threaded properly onto the blender container base, and securely tightened before placing food or liquid in the container. • To ensure proper assembly, place the blender container upside down and turn the collar counterclockwise until securely tightened. 3. Place assembled blender jar on unit base so that it is firmly seated and not tilted to one side. Never place the collar or blade assembly on the unit base unless the container has been completely assembled and securely tightened. How To Disassemble & Clean Containers with Removable Blades Always wash and rinse container immediately after use. 1. Be sure the switch is in the OFF position. 2. Remove the container assembly from the unit base and empty the contents. 3. To disassemble the Waring Pro® Tailgater™ Blender, turn container collar clockwise. 4. The collar, blade assembly and gasket are dishwasher safe. The plastic container lid and insert must be washed by hand. Allow all parts to air dry. 5. Be certain all components are in the proper position when reassembling blender container and base. 6 How To Clean unit Base To clean the unit base, unplug the power cord. Wipe the exterior surfaces with a soft cloth or sponge dampened with cleaning solution. Rinse with clean water. Do not immerse the base in cleaning solution or water. Wipe the base with dry towel. Fuse Replacement The plug on the blender power cord contains a replaceable cartridge fuse. To gain access to the fuse, push the metal tip of the plug inward as far as it will go, then turn it counterclockwise until it releases. Withdraw the tip, with the fuse attached, by pulling it straight out of the plug body. Replace fuse with one of same size and rating (15 Amperes, 32 Volts, Slow-Blow). Reassemble plug by reversing above procedure. Any other servicing should be performed by an authorized service representative. 7