Waring WSC300 Instruction Manual - Page 4
Parts, Specifications, Operating Instructions
View all Waring WSC300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
PARTS 5 4 10 7 4 6 1 3b 3a 3b 3c 2 1. ON/OFF Rocker Switch 2. Ready Indicator Light 3. Control Panel a. Time and Temperature Settings b. + and - Buttons c. Start/Stop Timer Button 4. Housing 5. Handle 6. Base 7. Nonstick Cooking Surface 8. Power Cord (not shown) 9. Rubber Feet (not shown) 10. Spatula 6 SPECIFICATIONS Model WSC300 Electrical 120V, 60Hz, 1800W Plug 5-15P Out of Box Dimensions: Depth - 21.875 inches (55.5 cm) Width - 15.5 inches (38.7 cm) Height Closed - 9.375 inches (23.8 cm) Height Open - 24.75 inches (62.9 cm) Cooking surface diameter - 13.5 inches (34.5 cm) Approval TUVus, NSF OPERATING INSTRUCTIONS 1. Plug the cord into an outlet, and flip the rocker switch to ON; switch will illuminate to indicate power. 2. Default temperature is 350°F (177°C). To change the temperature, press Settings button to toggle from time to temperature. Hold down the Settings button for 3 seconds until flashing. Use the + or - buttons to change the temperature. Setting will be saved after 5 seconds. 3. Timer defaults to 1 minute. To change the time, hold down the Settings button for 3 seconds. Use the + or - buttons to change the time. Setting will be saved after 5 seconds. 4. When the unit is preheated to the set temperature, the unit will beep and the ready light will illuminate. Preheating time will take approximately 6 minutes depending on set temperature. 5. Pour batter onto middle of cooking surface and close the lid. 6. If using the timer, press the Start/Stop Timer button. 7. Timer will beep 5 times when cooking cycle is complete. 8. Use the provided spatula to fold crêpes. Do not use sharp cooking utensils, as they could scratch the nonstick cooking surface. 9. Repeat this process for additional crepes. Adjusting Settings TEMPERATURE To change the temperature, press Settings button and then hold down the Settings button for 3 seconds, until flashing. Use the + or - button to change the temperature. TIMER To change the timer, hold down the Settings button for 3 seconds. Use the + or - button to change the time. 7