Weber Genesis 1000 NG Owner Manual - Page 14
Step 10, Step 9 - manifold
View all Weber Genesis 1000 NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Step 9 Install manifold bracket You will need: manifold bracket Hook the bracket onto the manifold at the center burner valve. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace. Figure 10. Frame brace Manifold bracket Step 10 Install igniter Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system. The igniter lock nut is on the igniter. Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 11 (b). Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Figure 11 (c). Tighten the igniter lock nut. Figure 11. Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers. (a) Figure 10 Frame brace (b) Figure 11 Keyhole in frame brace Igniter lock nut (c) Frame brace Small part of keyhole in frame brace 14