Weber Genesis 1500 NG Owner Manual - Page 23
Install Lid, Add tool holders, control panel and burner control knobs, control panel and burner
View all Weber Genesis 1500 NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Step 18 Install Lid You will need: lid, two hinge pins and two hair pin cotters. Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 30. Hair pin cotter Hinge pin Step 19 Add tool holders, control panel and burner control knobs You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs. Hook the tool holders over the frame rail and snap down into place. Figure 31. Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 31 (a). Push on the burner control knobs. Figure 31 (b). Insert in Crossover frame brace Ignition Button (a) Figure 30 Control panel push-in buttons (b) Tool holders Figure 31 23