Weber Genesis 2 NG Owner Manual - Page 27
Crossover Ignition System Operations
View all Weber Genesis 2 NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
i) Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the Venturi fins. There should be no gaps in the seams or in the fit around the burners and valves. Figure 14. Venturi fin Check fit around valve Crossover Ignition System Operations If the Crossover Ignition System fails to ignite the Front burner, light the Front burner with a match. If the Front burner lights with a match, then check the Crossover Ignition System. s Check that both the white and black ignition wires are attached properly. Figure 15. White wire Check fit around burner Figure 14 ƽCAUTION: If the Spider Stopper Guards do not fit tightly, contact Weber-Stephen Customer Service. ƽCAUTION: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue. (See Step"Check for gas leaks".) Black wire Figure 15 s Check that the Crossover Ignition button pushes the igniter (button) down, and returns to the up position. s Check to see if the igniter is loose in the frame. Tighten if necessary; see Step "Install igniter" for correct procedure. If the Crossover Ignition System still fails to light, See Section "Manual Lighting", and contact Weber-Stephen Customer Service. 27