Weber Genesis 4 LP Owner Manual - Page 17
Step 15
View all Weber Genesis 4 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Step 15 Install left hand swing table You will need: swing table end bracket, two 10-24 hex nuts, two 10-24 x 1 3/4 inch machine screws, left hand slide bar assembly, swing table, four nylon washers, screwdriver and pliers. Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 17 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 17 (b). The rod should swing freely inside the locking tab. Figure 17 (c). (b) (c) Insert one end of the hinge rod into the hole in the frame. Figure 18 (a). Insert the other end into the hole in the swing table end bracket. Figure 18 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 18 (c). To fully seat the bracket, you may have to tap it lightly with a hammer. ƽWARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call our Customer Service Center to order a new part. ƽWARNING: The load limit for the swing table is 30 pounds. Hinge rod (a) (b) Support rod (a) Figure 17 View from rear of barbecue (c) Figure 18 Slot in frame (view from below) 17