Weber Genesis 5000 NG Owner Manual - Page 22
WARNING: If swing table end bracket is in any
View all Weber Genesis 5000 NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Insert one end of the hinge rod into the hole in the frame. Figure 30 (a). Insert the other end into the hole in the swing table end bracket. Figure 30 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 30 (c). To fully seat the bracket, you may have to tap it lightly with a hammer. ƽWARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call our Customer Service Center to order a new part. ƽWARNING: The load limit for the swing table is 30 pounds. (a) (b) View from rear of barbecue Hinge rod Position slide bar assembly on the outside of the wheel frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 31. Notch Slide bar View from front of barbecue Figure 31 Wheel frame To lower table: Pull support rod up to disengage slide lock and lower table. To raise table, lift table up and engage slide in locked position. Figure 32. Support rod (c) Slot in frame (view from below) Figure 30 Slide Unlocked position Locked position Figure 32 22